PERBANDINGAN PERILAKU BALOK TANPA SAMBUNGAN LEWATAN DAN BALOK DENGAN SAMBUNGAN LEWATAN

Sulastri Sulastri

Abstract


Placement and strength of joints must be planned well so as not to cause collapse in the structure. Lap splices the reinforcement must be able to transfer the forces acting on the reinforcement due to the load given. This study investigates the behavior of beams without lap splices and beams with lap splices. Specimens consist of two beams, namely beams without lap splices and beams with extended joints with lap splices  (ld) of 640 mm. The test is carried out with a pure bending test method with loading of Two Point Loads on a simple support beam. From this study, the maximum flexural load on the beam without a connection is obtained from 115.41 kN with a maximum deflection of 16.41 mm. For beams with a channel length of 640 mm, the maximum bending load of 124.804 kN was obtained with a deflection of 25.02 mm. The results showed that the reinforced bonding joints that were properly implemented were able to channel the forces acting on the reinforcement until the beam reached its capacity.

Keywords: splice length; lap splices; bending strength ; concrete beam test; deflection

Full Text:

PDF

References


SNI-2847-2013. (2013). Persyaratan beton struktural untuk bangunan gedung. Bandung: Badan Standardisasi Indonesia, 1–265.

Nawy, E. G. (Ed). (2008). Concrete Construction Engineering Handbook, 1584.

Tumiwa, B., Manalip, H., & Tamboto, W. J. (2016). Pemeriksaan Tegangan Lekat Antara Baja Dan Beton Dengan Kuat Tekan Beton 40 MPa, 4(1).

Paulay, T., and Priestley, M.J.N., (1992), “Seismic Design of Reinforced Concrete and Masonry Buildings”, John Wiley & Sons, Inc., New York.

Dipohusodo, Istimawan 1994 Struktur Beton Bertulang. Jakarta: Gramedia Pustaka Utama.




DOI: https://doi.org/10.37721/kalibrasi.v3i2.742

Refbacks

  • There are currently no refbacks.


Alamat sekretariat : Fakultas Teknik Un-Bor. Jl. Raya Kalimalang No. 1 Jakarta 13430

Telp. 021 8613868; 8613877, e-mail : jurnal.teknik@borobudur.ac.id   

Jurnal KaLIBRASI ini merupakan Jurnal Ilmiah yang diterbitkan untuk publikasi disiplin ilmu Teknik, yang mencakup Prodi Teknik Sipil, Prodi Arsitektur dan Prodi Teknik Industri

Jurnal diterbitkan dua kali setahun pada bulan Maret dan September